2adjusting feed draper tension, Adjusting feed draper tension, 2 adjusting feed draper tension danger – MacDon FD75 OM User Manual
Page 337
7.
Install new draper over drive roller (A) with chevron
cleat (B) pointing to front of adapter. Make sure draper
guides fit in drive roller grooves (C).
8.
Pull draper along bottom of adapter deck and over
draper supports (D).
Figure 6.137
A - Drive Roller
B - Chevron Cleat
C - Drive Roller Grooves
D - Draper Supports
9.
Connect draper joint with straps (A). Secure with nuts
and screws.
Screw heads should face toward rear
of the deck.
Tighten nuts so that end of screw is
approximately flush with nut.
10. Adjust draper tension.
See
Figure 6.138
6.9.2
Adjusting Feed Draper Tension
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. Refer to the combine
operator’s manual for instructions regarding the proper use and storage of header safety props.
169894
323
Revision A