MacDon FD75 OM - Manual (Page 258)

MAINTENANCE AND SERVICING
6.2.2 Recommended Fluids and Lubricants
Your machine can operate at top efficiency only if clean lubricants are used.
• Use clean containers to handle all lubricants.
• Store in an area protected from dust, moisture, and other contaminants.
Lubricant Specification Description Use Capacities
High Temperature Extreme
Pressure (EP2) Performance
With 1% Max.
Molybdenum
Disulphide (NLGI Grade 2)
Lithium Base
As Required Unless
Otherwise Specified.
—
Grease
SAE
Multi-Purpose
High Temperature Extreme
Pressure (EP) Performance
With 10% Max. Molybdenum
Disulphide (NLGI Grade 2)
Lithium Base
Driveline Slip-Joints —
Knife Drive Box 2.3 quarts (2.2 liters)
Gear
Lubricant
SAE 85W-140 API Service Class GL-5
Main Drive Gearbox 5 pints (2.5 liters)
Hydraulic
Oil
SAE 15W-40
Compliant With SAE Specs
For API Class SJ And CH-4
Engine Oil
Header Drive Systems
Reservoir
16 US gallons
(60 liters)
6.2.3 Torque Specifications
The following tables give correct torque values for various bolts, cap screws, and hydraulic fittings.
• Tighten all bolts to the torques specified in chart (unless otherwise noted throughout this manual).
• Replace hardware with the same strength and grade bolt.
• Check tightness of bolts periodically, using the tables below as a guide.
• Torque categories for bolts and cap screws are identified by their head markings.
SAE Bolt Torque Specifications
Torque values shown in this table are valid for non-greased, or non-oiled threads and heads. Therefore, do NOT
grease or oil bolts or cap screws unless otherwise specified in this manual.
169894 244 Revision A