Adjusting reel frown – MacDon FD75 OM User Manual
Page 365
Adjusting Reel Frown
The frown is adjusted by repositioning the hardware connecting the reel finger tube arms to the reel discs.
To adjust the reel frown, follow these steps:
NOTE:
The frown profile should be measured prior to reel disassembly for servicing so that the profile can be
maintained after reassembly.
1.
Position the reel over the cutterbar (between ‘4’ and
‘5’ on the gauge).
This position provides adequate
clearance at all reel fore-aft positions.
2.
Record a measurement at each reel disc location for
each reel tube.
Figure 6.196: Arm Decal
3.
Adjust the profile as follows: Start with the reel disc set
closest to center of header and proceed to the ends.
a.
Remove bolts (A).
b.
Loosen bolt (B) and adjust arm (C) until desired
measurement is obtained between reel tube
and cutterbar.
NOTE:
Allow the reel tubes to find a natural
curve
and
position
the
hardware
appropriately.
c.
Reinstall bolts (A) in aligned holes and tighten.
Figure 6.197
169894
351
Revision A
- M205 Operators Manual (482 pages)
- M155 Operators Manual (458 pages)
- M205 Quick Card (2 pages)
- M105 Quick Card (2 pages)
- M155 Quick Card (2 pages)
- M100 SP Operators Manual (193 pages)
- M150 SP (234 pages)
- 9352c SP (155 pages)
- 9352i SP (155 pages)
- 9250 SP (160 pages)
- D65 SP DHOM (292 pages)
- D65 Quick Card (2 pages)
- D50 Quick Card 2011 (4 pages)
- D50 Quick Card 2012 (2 pages)
- FD75 (42 pages)
- CA25 OM (205 pages)
- DWA for M Series (50 pages)
- HC10 for D-Series (154 pages)
- D60 Operators Manual (49 pages)
- D50 Draper Headers (160 pages)
- 972 HARVEST HEADER (124 pages)
- 962 Harvest Header (86 pages)
- 963 Harvest Header (87 pages)
- A30-D (182 pages)
- A Series Quick Card (2 pages)
- A30-D (193 pages)
- 912 (84 pages)
- R85 Rotary Disc 13 Foot Self-Propelled Windrower Header (168 pages)
- R85 Rotary Disc 16 Foot Self-Propelled Windrower Headers (182 pages)
- R80 Rotary Disc (103 pages)
- FD75 Combine Header Quick Card (2 pages)
- D65 Combine Header Quick Card (2 pages)
- 974 Quick Card (4 pages)
- CA20 Operators Manual (100 pages)
- 871 Combine Adapter (68 pages)
- D50 for Combine Operators (246 pages)
- 973 Harvest Header (95 pages)
- 872 Combine Adapter (72 pages)
- 873 Combine Adapter (91 pages)
- PW8 Pick-Up Header (196 pages)
- PW7 Pick-Up Header (91 pages)
- R85 Rotary Disc 16 Foot Pull-Type (244 pages)
- R85 Rotary Disc 13 Foot (123 pages)
- R85 Rotary Disc 13 Foot Pull-Type (103 pages)