9adapter feed draper, 1replacing adapter feed draper, Adapter feed draper – MacDon FD75 OM User Manual
Page 336: Replacing adapter feed draper, 9 adapter feed draper, Caution, 1 replacing adapter feed draper
6.9
Adapter Feed Draper
CAUTION
To avoid personal injury, before servicing machine or opening drive covers, refer to
.
6.9.1
Replacing Adapter Feed Draper
The draper should be replaced or repaired if it is torn, missing slats, or cracked.
1.
If header is attached to combine , detach the header from the adapter. Refer to
.
2.
Raise header fully, stop engine and remove key. Engage header safety props.
3.
To loosen draper tension, loosen jam nut (A) and
then hold nut (B) with a wrench and turn bolt (C)
counterclockwise to release tension. Do this to both
sides.
4.
Disengage header safety props and lower feeder
house and adapter onto blocks to keep adapter slightly
off the ground.
Figure 6.135: Tensioner
5.
Remove the draper connector straps (A) along
draper joint.
6.
Pull draper from deck.
Figure 6.136: Draper Connector
169894
322
Revision A