10tine tube bushings, Removing bushings from 5-, 6- or 9-bat reels, Tine tube bushings – MacDon FD75 OM User Manual
Page 390: Removing, 10 tine tube, 10 tine tube bushings, Warning
IMPORTANT:
Do NOT apply force to finger prior to tightening
mounting screw. Applying force to finger without
screw tightened will break finger or shear off
locating pins.
3.
Install
screw
(A)
and
torque
to
75–80
in·lbf
(8.5–9.0 N·m) with a Torx
®
-Plus 27 IP socket wrench.
Figure 6.261: Installing Finger
6.12.10
Tine Tube Bushings
Removing Bushings from 5-, 6- or 9-Bat Reels
NOTE:
If only replacing the cam end bushing, Refer to
6., Removing Bushings from 5-, 6- or 9-Bat Reels, page
Center Disc and Tail-End Bushings
WARNING
To avoid bodily injury from fall of raised reel, always engage reel safety props before going under raised
reel for any reason.
1.
Lower header, raise reel fully, and engage reel safety props.
IMPORTANT:
Ensure tine tube is supported at all times to prevent damage to the tube or other components.
2.
Remove reel endshields and endshield support (C)
from the tail end of the reel at applicable tine
tube location.
NOTE:
There are no endshields on the center
disks.
3.
Remove bolts (A) securing arm (B) to disc.
IMPORTANT:
Note the hole locations in arm and disc and
ensure bolts are reinstalled at original locations.
Figure 6.262: Tail End
169894
376
Revision A