Lenze 931E/K Small Drives Control - Manual (Page 90)

Commissioning
Course program
Application examples
5
l
90 SW−HB 13.0002−EN 4.1
5.5.15 Application examples
The following examples will give you an idea of the flexible solutions provided by the
course program.
Linear linkage of positions
Positions 1 – 2 – 3 – 18 are to be approached. The drive is to stop for 1 second at every
position. Then, the course program shall stop.
Pos 1 Pos 2 Pos 3 Pos 18
Start
Stop
931E_119
Fig. 13 Linear linkage of positions
Implementation:
931e_260
Implementation:
ƒ The start delay for positions 1, 2, 3 and 18 must be parameterised when the target
positions are programmed.