Lenze 931E/K Small Drives Control - Manual (Page 182)

Appendix
Parameter set management
General information
10
l
182 SW−HB 13.0002−EN 4.1
10.6 Parameter set management
10.6.1 General information
For trouble−free motor control with the 931E/K servo positioning controller, the
characteristics of the 931E/K servo positioning controller must have been set correctly. In
the following, the individual characteristics will be referred to as parameters; the total of
all parameters for a servo positioning controller/motor combination will be referred to as
parameter set.
The below figure describes the parameter set management:
931E_126
Fig. 36 Online parameterisation
0 PC
1 *.DCO file
2 Small Drive Control (SDC)
3 Reading from file and saving in servo
4 Reading from servo and saving in file
5 Serial communication
6 Servo controller
7 RAM
8 Flash
9 Default parameter set
: Controller reset
; Saving the parameter set
< Loading the standard parameter set