Lenze 931E/K Small Drives Control - Manual (Page 149)

Appendix
Parameterisation of outside motors
Display unit settings
10
l
149 SW−HB 13.0002−EN 4.1
10.1.11 Display unit settings
Select the menu Options
W Display units to enter the display unit settings for position,
speed and acceleration. The display units are only used for the display in the
parameterisation program. The parameterisation program communicates with the
controller via communication objects in a defined physical base unit. Every access via the
RS232 interface is made in these base units.
Display units
The user can select display units for the following physical values:
ƒ Position / revolutions
ƒ Speed
ƒ Acceleration
ƒ Torque (in Nm or A)
931e_302