Lenze 931E/K Small Drives Control - Manual (Page 29)

Commissioning
Speed control
Setpoint selection via setpoint selectors
5
l
29 SW−HB 13.0002−EN 4.1
U
931E_118
Fig. 1 Safe zero
0 Setpoint
1 Safe zero
)
Note!
In applications with position control (internal or via the extern control), the
function "safe zero" must not be activated, because activation will have the
same control effects as a dead band or "backlash" in the controlled system.
During operation, this will lead to a reduced stability of the control circuit.
This menu contains separate tabs for the analog inputs. In this way, the inputs can be
scaled independently of each other.