Lenze 931E/K Small Drives Control - Manual (Page 125)

Troubleshooting
and fault elimination
Error message
9
l
125
SW−HB
13.0002−EN 4.1
9.2 Error message
The following table gives you an overview of the errors that may occur.
In the response column, you can find the possible reactions that can be parameterised by the user. They are marked with a
þ .
)
Note!
The parameterisation of the possible errors is described in the chapter "Error management"! (
¶ 132)
Response Meaning Response of drive
A Immediate switch−off of power stage The motor will coast to standstill.
H Emergency stop The motor will be decelerated at its current limit to zero speed. If a motor holding brake
is available, it will be applied. The power stage will be switched off.
W Warning The controller will continue operation, the power stage will remain switched on. The
warning can be read via the CAN bus or the serial RS232 interface.
O Off The warning will be suppressed − no response.
Symbols used:
Symbol Meaning
þ Default setting
¨ Response can be parameterised in SDC
− Selection not possible