Lenze EtherCAT control technology - Manual (Page 11)

DMS 3.1 EN 01/2011 TD17
L
11
Control technology | EtherCAT communication manual
About this documentation
Terminology used
1.3 Terminology used
Term Meaning
»Engineer« Lenze engineering tools supporting you during the entire life cycle of a machine
- from the planning phase to maintenance.
»EtherCAT Configurator«
»Global Drive Control« (GDC)
»PLC Designer«
Code
"Container" for one or several parameters used for Lenze Servo Drives parameter
setting or monitoring.
Subcode If a code contains several parameters, they are stored in "subcodes".
In the documentation the diagonal slash "/" is used as a separator between the
designation of the code and subcode (e.g. "C00118/3").
IPC Industrial PC
PLC Programmable Logic Controller
AT-EM EtherCAT master
CoE CANopen over EtherCAT
DC Distributed clocks (distributed synchronised clocks)
EoE Ethernet over EtherCAT
FoE File access over EtherCAT
MCF Master configuration file (XML file for EtherCAT bus configuration)
SoE Servo drive profile over EtherCAT
FB Function block (contained in a function library)
FUN Function (contained in a function library)