JUMO 706030 LOGOPRINT 500 Printing Recorder Operating Manual - Manual (Page 42)

3 Operation and visualisation
42
3.5.7 “Power On” and “Power Off” texts
The time of “Power On” and “Power Off” can be documented by using this
feature. Both texts are printed in red, with the date and time of the event. The
print-out can be inhibited through the configuration.
The priority cannot be assigned. It is always higher than that for the texts
which have a configurable priority. Both texts are configured through the pa-
rameter Configuration level 2
Î Print “Power on” text and Configuration level 2
Î Print “Power off” text.
H
Fixing the printing priority applied to the text for Speed change-
over affects not only the print-out of the marking at change-over,
but also the change-over itself.
v Section 3.5.1 “Printing priorities”
As long as a text with a higher priority is being printed, a change-
over will not happen if the parameter Configuration level 2
Î Print
speed change is set to ON. Otherwise, the change-over takes
place at once.
H
Text printing in the mode “Overwrite measurement trace” can take
a very long time.
v Section 3.5.2 “Printing modes”
v In order not to delay the change-over of the paper speed, the
priorities for texts which are printed in this mode should be low-
er than the priority for speed/feed change-over.
H
The line which indicates the type of change-over will still be print-
ed, even if the corresponding text cannot be printed.
This is the case if, in the setup program, Text for speed change,
measurement trace: overwrite is configured under Edit
Î Print
texts in Print mode and a paper feed/speed of 0 mm/h has been
set.
H
Text printing is relatively quick in the mode “Interrupt measurement
trace”.
v Section 3.5.2 “Printing modes”
In order to avoid text printing in this mode being cancelled by a
change-over of the paper feed, the priority for these texts should
be higher than the priority for paper feed change-over.