JUMO 706030 LOGOPRINT 500 Printing Recorder Operating Manual - Manual (Page 38)

3 Operation and visualisation
38
3.5.5 Report
The report is used to create statistics about the measurements, referred to a
definable period of time (statistical period).
The minimum, maximum and average values of the measurements are calcu-
lated for the statistical period. The result is printed out at the end of the statis-
tical period, in the form of a table.
When selecting the report it is possible to choose between two types of report.
The instance number on the print-out (1 or 2) identifies the type.
The texts “to”, “MIN.”, “MAX.”, “AVER.” and “DIM.” are printed in the language
which has been configured. Only channels which are actually present and
which have the plot status activated are included in the report.
If an overrange or underrange has occurred during the statistical period, then
“--------” will be printed out instead of the minimum, maximum and average
values.
The report is activated through the parameter Configuration level 2 Î Report.
Available selections are: “periodic”, “weekly”, “monthly” or “external” report.
Example:
A “periodic report” has been selected, with “report time 17:15 hrs.“ and “inter-
val 2 hrs.”. This means that the first report will be produced at 17:15. Further
reports will be made at 19:15, 21:15 etc.
H
Please note, that the calculation of the average value is more ac-
curate for the “periodic” report than for all other types of report
(statistical period longer than one day).
Report no. and recorder designation
Start report (date + time)
till
Report end (date + time)
MIN. MAX. AVER. DIM.
Designation ch. 1 min. value 1 max. value 1 average 1 unit
Designation ch. 2 min. value 1 max. value 1 average 1 unit
Designation ch. 3 min. value 1 max. value 1 average 1 unit
Designation ch. 4 min. value 1 max. value 1 average 1 unit
Designation ch. 5 min. value 1 max. value 1 average 1 unit
Designation ch. 6 min. value 1 max. value 1 average 1 unit