JUMO 706030 LOGOPRINT 500 Printing Recorder Operating Manual - Manual (Page 103)

103
12 Appendix
12.2 Hardware fault
If one of the following faults occurs, then the recording is aborted and the error
message will be shown in a flashing display.
The relay will react as in the event of a probe break
1
. The instrument no longer
responds to any kind of event, and cannot even be operated or controlled.
Please contact the nearest JUMO office or the main factory.
1. The reaction to a probe break is configured in the setup program or through the
parameter Configuration level 1 Î Limit comparator ÎProbe break (
Ö
Section 4.2
“Table of the configuration parameters”)
Display Cause / Remedy
EEPROM-ERROR! - The EEPROM in the printing recorder is
faulty, the configuration data can no longer
be stored.
- Please contact the nearest JUMO office or
the main factory.
NO ZERO! - The limit sensor (print head) was not
recognised.
- Please contact the nearest JUMO office or
the main factory,