JUMO 706030 LOGOPRINT 500 Printing Recorder Operating Manual - Manual (Page 20)

2 Instrument description
20
After a valid code number has been entered, the following parameters can be
altered in the parameter level:
- language
- date & time
- summer time
- display brightness
- display time
Configuration
level 1 (C1-level) Channel-specific parameters can be configured in configuration level 1. This
level can be accessed from the parameter level with the aid of the
h + R keys,
or from configuration level 2 by using
e.
Configuration level 1 includes the following channel-specific parameters:
- plot status
- signal input
- scaling
- channel name (word and number)
- limit comparator
- limit feed
- zoom
- presentation range (offset)
- peak value recording
H
If the same figures are used for both code numbers, then these
code numbers will be interpreted as code numbers for the com-
plete parameter set.
H
The relays in the external relay module ER8 remain in their present
state. They will only be switchable again when the printing record-
er has been returned to the operating level or the basic status.
H
If a correct code number is entered when calling up the parameter
level, then the signal acquisition and recording will be interrupted
in this level. The parameters can be viewed and altered.
H
The relays of the external relay module ER8 remain in the present
state. They will only be switchable again when the printing record-
er has been returned to the operating level or the basic status.