JUMO 709061 TYA 201 - Single-Phase Power Controller Operating Manual - Manual (Page 67)

2012-12-01/00561071 [SCR Power Controller TYA201] 65
5 Configuration
5.1.7 Binary output
This parameter specifies which control direction the binary output should have. It is
controlled by the multi-input interference signal.
v Chapter 8.1 "Binary signal for collective fault"
h
Switch to the configuration level
r
Binary output using the key
Value/settings Description
Control direction,
binary output N/O contact No fault message present:
14 and 15 pole and N/C contact closed or
13 and 15 optocoupler collector-emitter loop high-impedance
Fault message present:
13 and 15 pole and N/O contact closed or
13 and 15 optocoupler collector-emitter loop low-impedance
N/C contact No fault message present:
13 and 15 pole and N/O contact closed or
13 and 15 optocoupler collector-emitter loop low-impedance
Fault message present:
14 and 15 pole and N/C contact closed or
13 and 15 optocoupler collector-emitter loop high-impedance
k
/ bold = factory setting
13
14
15 E
S
C
Ö
P
Optocoupler Relay
13
14
15 E
S
Optocoupler Relay
C
Ö
P
13
14
15 E
S
Optocoupler Relay
C
Ö
P
13
14
15 E
S
C
Ö
P
Optocoupler Relay