JUMO 709061 TYA 201 - Single-Phase Power Controller Operating Manual - Manual (Page 44)

4 Operation
42 2012-12-01/00561071 [SCR Power Controller TYA201]
Using and the current measured values such as currents, voltage
actual values, setpoint value load resistance, device temperature, and power
can be viewed.
This information is also displayed in the diagnosis window of the setup pro-
gram.
v Chapter 7 "Setup program"
4.1.2 Displaying measured values
Overview of
measured val-
ues At this level, the designation of the measured value is displayed in the top row,
and the numerical value together with the unit of measurement is displayed in
the middle row.
The info line shows the selected input (with terminal designation), the set sub-
ordinate control loop, and the operating mode.
It is also used to display temporary states (e.g. error messages).
v Chapter 8 "Fault messages and alarms"
Meaning of the
symbols in the
info line
Designation
Measured value
Info line or error
Input signal Subordinate
control loop Operating mode
load output
Voltage None Phase angle control
Current U
2
Soft start in phase an-
gle control
Interface I
2
Burst-firing mode
Binary input1 U Burst-firing mode with
α
start
Binary input2 I Half-wave control
Input signal in-
correctly
configured P General logic
Logic
(switch) Logic with
α
start
Invalid control
configured Logic with
α
default
values
Logic with
α
start and
α
default values
Firing-pulse inhibit