JUMO 709061 TYA 201 - Single-Phase Power Controller Operating Manual - Manual (Page 5)

2012-12-01/00531796 [Thyristor Leistungsschalter TYA201] 3
Inhalt
5.1.4 Setpoint value configuration ............................................................................ 59
5.1.5 Monitoring .......................................................................................................... 61
5.1.6 Binary inputs ...................................................................................................... 63
5.1.7 Binary output ...................................................................................................... 65
5.1.8 Actual value output ............................................................................................ 66
5.1.9 RS422/485 .......................................................................................................... 66
5.1.10 PROFIBUS-DP .................................................................................................... 67
5.1.11 Changing codes ................................................................................................. 67
5.2 Configuration example ............................................................................ 68
6 Special device functions ...........................................................69
6.1 Detection of load faults ........................................................................... 69
6.1.1 Teach-in .............................................................................................................. 71
6.2 Manual mode ............................................................................................ 72
6.2.1 Default setpoint value in manual mode ........................................................... 72
6.2.2 Configuring the teach-in (prerequisite for teach-in in manual mode) .......... 72
6.2.3 Performing teach-in in manual mode .............................................................. 73
6.3 Default setpoint value via potentiometer .............................................. 74
6.4 Dual energy management ....................................................................... 74
6.5 Subordinate control ................................................................................. 76
6.5.1 Closed control loop without subordinate control ........................................... 76
6.5.2 Closed control loop with subordinate control ................................................ 77
6.6 Resistance limitation (R control) ............................................................ 82
6.7 Current limiting ........................................................................................ 83
6.8
α
start ........................................................................................................ 84
6.9 Monitoring of the supply voltage drop ................................................... 84
6.10 Firing-pulse inhibit ................................................................................... 84
6.11 SCR control logic (switch) ....................................................................... 85
7 Setup program ...........................................................................87
7.1 Hardware .................................................................................................. 87
7.2 Compatible operating systems ............................................................... 87
7.3 Installation ................................................................................................ 88