INFICON Composer Elite Gas Concentration Monitor - Manual (Page 45)

3 - 5
PN
07
4-
56
6-
P1
B
Composer Elite Operating Manual
3.3.2 Composer Elite Screen Descriptions
Boot Screen, see section 3.3.2.1
Indicators Displayed On Screens, see section 3.3.2.2 on page 3-6
Overview Screen, see section 3.3.2.3 on page 3-6
System Overview Screen, see section 3.3.2.4 on page 3-8
Errors and Warnings Screen, see section 3.3.2.5 on page 3-9
Sensor Screen, see section 3.3.2.6 on page 3-10
Sensor Parameters Screen, see section 3.3.2.7 on page 3-12
3.3.2.1 Boot Screen
During power-up of the Sensor Control Unit, the INFICON logo is displayed. The
following information is briefly displayed before the System Overview screen is
displayed:
 Version x.xx.xx HW x (Control card firmware version and hardware version)
 Loading....... Please Wait (while Data, Sensor, and DeviceNet statuses are
being determined) followed by Loading....... Complete
 Data Wait followed by:
 Data OK (if parameter values were retained in memory)
 Data Reset (if memory was cleared to factory default parameter values;
refer to
section 3.2.4 on page 3-3)
 Parameter Error (contact INFICON if this message appears)
 Sensor Data Error (contact INFICON if this message appears)
 System Data Error (contact INFICON if this message appears)
 Searching followed by:
 DeviceNet Detected (if a DeviceNet module is installed in the Control card)
 DeviceNet Not Detected (if a DeviceNet module is not installed)
 DeviceNet Error (if there is a problem with the DeviceNet module)
 Initializing followed by:
 Sensor n Detected (for installed Sensor cards)
 Sensor n Not Present (for empty Sensor card slots)
 Sensor n Initialization Failed (if there is a problem with a Sensor card)