Force parameters to their default values, Turn the key board beeper on/off, Internal use commands – INFICON STM-100/MF Thin Film Deposition Monitor User Manual
Page 68: Multi-film film number selection, Page 5 - 13 computer interfacing
_________________________________________________________________________
Command:
b
Parameter:
none
Description:
This command forces the internal working parameter values to their default values (
Film = 1.0, Density = 1.0, Z-Factor = 1.0, End Thickness = 0, Setpoint Thickness = 0,
Setpoint Timer = 00:00, and Tooling = 100%). This is primarily used for testing at
Sycon, but can be used to set the instrument into a known configuration.
_________________________________________________________________________
Command:
c
Parameter: [@, !, ?]
Description:
Set or query the Keyboard beeper mode. At power up the STM-100 / MF beeper
sounds with each keypress. This can be toggled on and off via the keyboard (see
Section 2.7) or via this command. The '@' modifier turns off the beeper, the '!'
modifier turns it on, and the '?' requests the current beeper status, returned as either
'!' (ON) or '@' (OFF).
_________________________________________________________________________
Command:
d
Description:
System reset, computer requests a startup reset. Special Internal use.
_________________________________________________________________________
Command:
e
Argument:
[XX]
Description:
Relay Over-ride, followed by 2 hex characters to substitute for current relay mask.
Special Internal use.
_________________________________________________________________________
Command:
f
Description:
Reserved for Internal Use.
_________________________________________________________________________
Command:
g
Description:
Reserved for Internal Use.
_________________________________________________________________________
Command:
h
Description:
Reserved for Internal Use.
_________________________________________________________________________
Command:
i
Argument:
[=1 thru 9] l [?]
Description:
Set or query the current film. Example: command i=6, sets the current film to film 6.
Force Parameters to
Their Default Values
Turn the Key Board
Beeper On/Off
Internal Use
Commands
Multi-Film Film
Number Selection
Page 5 - 13
COMPUTER INTERFACING