INFICON STM-100/MF Thin Film Deposition Monitor - Manual (Page 29)

CONFIGURATION
SWITCH
BINARY DEVICE ADDRESS
SW8=MS BIT SW12=LS BIT
SW 8 SW9 SW10 SW11 SW12
OFF OFF OFF OFF OFF = 0
OFF OFF OFF ON OFF = 0
ON OFF ON OFF ON = 0
SERIAL BAUD RATE
SW 6 SW7
OFF OFF = 300
OFF ON = 1200
ON OFF = 2400
ON ON = 9600
PROTOCOL ON = SEMI OFF = SYCON
NEGATIVE RATES ON = ENABLE OFF = DISABLE
FREQUENCY MODE ON = ENABLE OFF = DISABLE
ANALOG OUTPUT ON = THICK OFF = RATE
PARAMETER LOCK ON = LOCK OFF = UNLOCK
see Note:
NOTE: Switch settings involving communications functions are sensed at power up only.
Figure 2.13: Configuration Switch Settings.
SWITCH FUNCTION DEFINITIONS
SW1 - PARAMETER LOCK
When on, stored parameter data cannot be modified via the front
panel. This switch is sensed at all times.
SW2 - RECORDER FUNCTION
When on, the analog output will provide thickness information.
Rate information is presented in the off state. This switch is
sensed at all times. See Section 3.6.
SW3 - FREQUENCY MODE
When on, the unit will display seven digits of sensor frequency to
a resolution of one Hertz. All other instrument functions remain
normal. This switch is active at all times.
SW4 - NEGATIVE LIMITS
When on, both thickness setpoints and their associated relays will
activate on negative thickness data only. This switch is sensed at
all times.
SW5 - SERIAL COMMUNICATIONS FORMAT
When on, the RS-232 serial communications channel will respond
to SEMI STANDARD SECS-II formatted commands. Sycon
formatted commands are valid for the off state. This switch is
sensed only at power-up.
SW6 & SW7 - BAUD RATE SELECTION
These two switch settings in combination select one of four baud
rates for the RS-232 serial communications channel. These
switches are sensed only during power-up.
Configuration
Page 2 - 9 OPERATION AND PROGRAMMING