Mounting a drd enclosure on a pedestal – ETC Unison DRd Dimming Rack Enclosure User Manual
Page 18
14
DRd Enclosure Installation Manual
Mounting a DRd Enclosure on a Pedestal
Step 3:
Remove the eight screws and washers that secure the front panel to the unit.
Step 4:
Position the floor stand on floor hardware previously placed for marking the
holes.
Step 5:
Secure the pedestal base to the floor.
Step 6:
Create conduit access in the bottom of the DRd enclosure. Notice the label inside
the bottom of the enclosure indicating the recommended locations for conduit
access. Do not create conduit access outside of the recommended locations.
Step 7:
Position the DRd on the floor stand pedestal and align with the mounting holes
provided.
Step 8:
Bolt the enclosure into place.
Step 9:
Reinstall the front panel to the pedestal unit, replacing all hardware removed in
step 3.
The Unison DRd pedestal is designed with the same footprint as the DRd enclosure.
The acceptable conduit access in the bottom of the DRd overlaps the floor stand access
panel for contractor wiring and installation convenience. It is recommended to secure a
DRd enclosure installed on a pedestal to a wall for greater stability.
432mm
17”
186.7mm
7.35”
35.5mm
1.4”
35.5mm
1.4”
Step 1:
Use the measured
dimensions in the
graphic (right) to mark
the hole locations for the
floor mounting hardware.
Step 2:
Drill holes for floor
mounting hardware.