beautypg.com

Preparations, Unpack and inspect, Main circuit breaker protection – ETC Unison ERn Wall-mount Control Enclosure User Manual

Page 10: Lockout / tagout, Unpack and inspect main circuit breaker protection, N o t e

background image

6

Unison

®

ERn Wall Mount Enclosure Installation Manual

Preparations

Unpack and Inspect

Before you begin installation, check your shipment and confirm it arrived complete and

undamaged.

Step 1:

Check the shipping container for physical damage.

Step 2:

If you find damage, document it to help with a claim against your shipper.

Step 3:

Unpack your order and check the contents against the packing list to be sure

your order is complete.

Step 4:

If you discover a problem, call ETC Systems Group at (608) 831-4116.

Main Circuit Breaker Protection

Before you begin installing the Unison

®

external processing rack enclosure, make sure you

have installed a main circuit breaker cabinet or other readily accessible input power

disconnect device in the same, room or in close proximity to the installed ERn enclosure.

Lockout / Tagout

Equipment should have power disconnected and be locked out while being repaired.

Accidents which occur because equipment that is being repaired and not locked out can

result in serious injuries like amputations, fractures, and even death. Locking out and

tagging power at its source is important while repairing or adjusting equipment because it

ensures that power does not reach the equipment being serviced.

To lockout means to place a lock on a device that prevents the release of energy.
Locking out is intended to prevent the unexpected startup or energizing of machinery
and equipment during service and maintenance operations.

To tagout means to place a tag on a switch or other shut off device which warns others
not to start the piece of equipment. Tagout should only be used with lockout, unless
locking out the equipment is impossible.

W A R N I N G :

Rack enclosures installed without an accessible power disconnect device

cannot be serviced or operated safely. Follow all local codes and

restrictions.
When the disconnect device is not located near the installed rack enclosure,

the disconnect must allow for proper lockout and tagout.

N o t e :

While ETC does not intend to qualify your facility Lockout/Tagout procedures, we

have provided a generic guide below for your reference as needed.