ETC Source Four LED v1.6.0 User Manual - Manual (Page 63)

3
Operation 57
Step 1: On the Sequences menu, scroll to Rate and press [ ].
Figure-3.24 Selecting Rate on the Sequences Menu.
Step 2: Press [ ] or [ ] to set the desired percent.
Step 3: Press [ ].
Step 4: Press [ ] to scroll to Step.
Step
You enter the number of the step in the sequence to be edited. In our example, you select
step 1. After setting the Preset and Link time, return to Step and select step 2. Repeat this
process until you have entered all the steps in the sequence.
Any change to Step is updated live in the fixture memory. Pressing [ ] does not undo a
change to Step.
Step 1: On the Sequences menu, scroll to Step and press [ ].
Figure-3.25 Selecting Step on the Sequences Menu.
Step 2: Press [ ] or [ ] to set the desired Step number.
Step 3: Press [ ].
Step 4: Press [ ] to scroll to Preset.
Sequences
Sequence: * 3
Action: Not Active
Rate : 100%
Step: 01
Preset: 1
Link Time: 00:02
Copy to Other Fixture
Sequences
Sequence: *3
Action: Not Active
Rate: 100%
Step : 01
Preset: 1
Link Time: 00:02
Copy to Other Fixture