ETC Source Four 26 Degree EDLT Aperture - Manual

E T C
®
I n s t a l l a t i o n G u i d e
Source Four
®
26 Degree EDLT Aperture
Source Four 26° EDLT Aperture Page 1 of 1 Electronic Theatre Controls, Inc.
Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736
London, UK  Unit 26-28, Victoria Industrial Estate, Victoria Road, London W3 6UU, UK  Tel +44 (0)20 8896 1000  Fax +44 (0)20 8896 2000
Rome, IT  Via Pieve Torina, 48, 00156 Rome, Italy  Tel +39 (06) 32 111 683  Fax +44 (0) 20 8752 8486
Holzkirchen, DE

Ohmstrasse 3, 83607 Holzkirchen, Germany

Tel +49 (80 24) 47 00-0

Fax +49 (80 24) 47 00-3 00
Hong Kong  Rm 1801, 18/F, Tower 1 Phase 1, Enterprise Square, 9 Sheung Yuet Road, Kowloon Bay, Kowloon, Hong Kong  Tel +852 2799 1220  Fax +852 2799 9325
Service: (Americas) [email protected]

(UK) [email protected]

(DE) [email protected]

(Asia) [email protected]
Web: www.etcconnect.com  QSF 4.1.9.1  Copyright © 2012 ETC. All Rights Reserved.  Product information and specifications subject to change.
7060M2100  Rev A  Released 2012-05  ETC intends this document to be provided in its entirety.
Overview
The following procedure describes how to install an aperture into a Source Four 26 degree EDLT. The
aperture is used to improve performance by reducing flare with Source Four and Source Four LED
fixtures.
Opening the Lens Tube
To install the aperture, you must first open the lens tube.
Step 1: Place the lens tube on its side on a smooth surface.
Step 2: Remove the 4 screws and barrel knob. For CE lens
tubes also remove the retaining screw assembly.
Step 3: Carefully separate the lens tube halves. Ensure that
the lens and lens pads remain in the bottom half.
Set the top half without the lens to the side.
Only On CE Lens Tubes
Aperture Installation
Step 4: Place the aperture in the
first slot directly behind the
rear lens. Orient the
aperture so that its flat
sides are against the sides
of the bottom half of the
lens tube. It does not
matter which side of the
aperture is facing the lens.
Step 5: Make sure the bottom
cutouts of the aperture are
around the circular posts
behind the lens.
Step 6: Carefully combine the two
halves of the lens tube,
making sure that the gel
retainer clip, lens, aperture,
and lens pads are lined up
properly.
Step 7: Reattach the screws and
barrel knob, and for CE
tubes, the retaining screw
assembly.
The cutouts on the aperture will be at the top
and bottom, and the flat areas will be against
the sides of the bottom lens tube.