Edit color (lustr+, series 2 lustr, and studio hd) – ETC Source Four LED v1.6.0 User Manual User Manual
Page 59
3
Operation
53
Figure-3.18 Selecting Delay Time on the Presets Menu.
Step 2:
Press [
] or [
] to set the desired time in minutes.
Step 3:
Press [
].
Step 4:
Press [
] or [
] to set the desired time in seconds.
Step 5:
Press [
].
Edit Color (Lustr+, Series 2 Lustr, and Studio HD)
Use Edit Color to change the overall brightness settings of all colors within the LED array.
You can change the predefined color mixes for the Preset. Refer to the table in
(Lustr+, Series 2 Lustr, and Studio HD), page 51
. You can also change the hue, saturation
and intensity of the predefined colors.
To keep your changes, be sure to select Save Changes and then press
[
].
To discard
changes press [
] at any time.
If the Preset is currently active, the changes made on the Preset Color Edit screen update
to the fixture output immediately.
Step 1:
On the Presets menu, scroll to Edit Color and press [
].
Figure-3.19 Edit Preset Color Screen.
Step 2:
With Color selected, press [
].
Step 3:
Press [
] or [
] to set the desired predefined color mix.
Step 4:
Alternatively, to edit the predefined color mix, scroll to any of the parameters on
the screen and press [
].
Step 5:
Press [
] or [
] to change the values.
Step 6:
Press [
].
Step 7:
Do one of the following:
•
Scroll to Save Changes and press [
].
•
Press [
] to exit the screen without saving the changes.
Presets
Preset: *
23
Status: Active
Fade Time:
00:02
Delay Time
: 00:00
Edit Color
Copy to Other Fixture
Save DMX as Preset
Preset 23 Color Edit
Color:
Int: 100%
Save Changes
Strobe: 255