2 operating and safety instructions, 1 safety instructions, Perating and – ADS-TEC RAP/RAC1000 User Manual User Manual

Page 9: Afety, Nstructions

IT Infrastructure RAP/RAC1000

PERATING AND

AFETY

NSTRUCTIONS

The unit operates under electrical tension and implements supersensitive component parts.
Intervention by the User is required only for power supply line connection operations.
Should any further alterations be required, it is necessary to consult either with the

Manufacturer directly or with authorised service personnel accordingly. During said
connection operations, the unit must be completely powered down. Specific requirements

need to be met concerning the prevention of electrostatic discharge on component
construction parts during contact. If the unit is opened up by a non authorised individual,
the User may be subject to potential hazards and, warranty conditions are terminated.
General Instructions:

•

This User’s Guide must be read and understood by all Uses and must be available
for consultation at all times

•

Mounting, operation start-up and unit operation must only be conducted by
appropriately qualified and trained personnel

•

All individuals and operators using the unit must strictly observe all safety and use
instructions as provided within the User’s Guide

•

All regulations and prescriptions on accident prevention and safety in force at the
unit installation site must be strictly observed at all times

•

This User’s Guide provides all the most important directions as required for safe
and security oriented operation

•

Safe and optimised unit operations are subject to appropriate storage, proper
transport and handling, accurate unit setup, start-up and operation

Note:
Only original ads-tec firmware / software is allowed for any of the adjustments and

features described in this User’s Guide. Deployment of any firmware / software that has

not been released by ads-tec will terminate all warranty conditions.

2.1

AFETY

NSTRUCTIONS

Warning:
In order to prevent possible unit damages, all cable lines (power supply, interface cables)

must be hooked up strictly with the unit in power-OFF conditions.

Warning:
All unit mounting operations must be strictly conducted under safe, secure and zero-

potential conditions.

Note:
When handling parts and components susceptible to electrical discharge, please

accurately observe all the relevant safety provisions.
(DIN EN 61340-5-1 / DIN EN 61340-5-2)