It infrastructure rap/rac1000 – ADS-TEC RAP/RAC1000 User Manual User Manual

Page 122

IT Infrastructure RAP/RAC1000

122

Multi client bridge:
This operating mode allows to use a WLAN client in connection with a non-ads-tec Access

Point. All devices connected with the Ethernet interface of the ads-tec device, are
automatically masked with the MAC address of the WLAN module of the ads-tec device in
the direction of the WLAN. The first device is masked with a layer2-transparent access, and

all further devices are masked with a layer3-transparent access, i.e. only protocol data
might be transmitted.
Single client bridge:
Exactly one Ethernet device, which is masked with a layer2-transparent access, may be

connected behind the client, in this case. The MAC address of this device must be manually
entered.

Note:
If the ads-tec device itself is configured as a DHCP client in the Single bridge mode or in

the Multi client mode, all other connected devices may also use DHCP. The ads-tec device

will automatically initiate DHCP relay in order to forward all corresponding requests.