2N Lift8 v1.5.2 - Manual (Page 46)

46
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Volume Configuration
Slightly loosen the four screws and shift the cover downwards. Now you can remove
the cover. Use the trimmer located in the bottom part of the electronics to set the
required volume level (see the figure below).
External Pictogram Driver
Description
The device transforms the Car Unit LED outputs into a universal pilot lamp, 2N Lift8
®
whose outputs are capable of driving two lamps rated at the maximum of 36 Volts, 0.5
Amps. The outputs are galvanically isolated from the Car Unit. Since the lamp outputs
are polarity independent, both AC and DC power supplies can be used for powering the
lamps. To protect the Car Unit and Pictogram Driver against damage caused by shorts,
always use the included isolating tube when installing the device!
Caution
Use the trimmer to set the best acoustic properties eliminating feedback.