2N Lift8 v1.5.2 - Manual (Page 134)

134
2N TELEKOMUNIKACE a.s., www.2n.cz
®
The other lift adding method is to create a lift card in the database. Click on Create lift
card to open a window in which you can set the contact number for lifts with one and
the same phone number. Click on the combo box to add another lift to a contact
number included in the database.
Confirm the number dialling to get into the General menu. Complete and save all
necessary data as described in the Lifts subsection below. As this lift has not made a
check call yet, it will be considered non-functional. Install it and make the first check
call to make the lift ready for use.
Each created lift is added to the end of the table. Select a lift for editing and
configuration. You can use multiselect to change (delete, export) parameters for a
higher number of lifts: either hold Ctrl to select the objects or hold Shift to select the
first and last objects thus selecting all the objects between them. All the changes or
exports made over the selected lifts will apply to all of them.
Lifts
Select a lift to open an extensive menu level with lift identification forms, check call
evaluations, maps and local plans of the building where the lift is installed. Let us
describe each of the forms.
Note
If the device that makes the first check call supports the CPC/P100
protocol, set the protocols in the configuration manually for check/alarm
calls. It is because the server always processes calls from an unknown
number by sending DTMF 5 and hang-up.
Note
Multiple lift functionality under one contact number is important where
lifts are connected to a gateway or PBX which identifies itself as a single
external number.
If you assign multiple lifts to one number, the evaluation logic will start
counting how many check calls have been received. The system waits
until the defined count of lifts call have arrived and then marks the whole
set of lifts under one contact number as functional. If one of the lifts fails
to call in the set interval, all the lifts are marked as non-functional.
Caution
The lift that fails to make a check call within the timeout will be marked as
non-functional and remain so until the next correct check call. A
non-functional lift is visible to the technician for check.
Tip
and are mandatory parameters for a new lift. Name Telephone number
Complete these values to validate and save the lift card. No more
parameters are necessary for the function. However, you are strongly
to facilitate lift advised to complete the whole lift card correctly
search and dispatchers' and rescuers' work.