2N Lift8 v1.5.2 User Manual

Page 147

147

Figure:

Groups – Lifts Menu

General

In the Groups – General menu, you can change the group name in the Name
parameter and assign lifts to the group. You can see a list of all lifts not assigned to the
group to the right and a list of all lifts in the group to the left. You can use the
searching function like in the group list. Select a lift and click the appropriate arrow to
move the lift to/from a group. You can use multiselect for selection. Furthermore, the
menu provides an extended setting, which helps you assign all parameters at once to
the given lift group. Define the Type of device:

2N LiftNet

2N SingleTalk

; refer to the lift creating subsection above for details. Enter the

Lift8

Unknown

Address of the building where the

is installed. This information will then be

displayed on the map for the technician's or dispatcher's needs. The Check call period
defines the check call timeout. The lift can call the

any time within

2N Lift8

Server

this timeout, but having exceeded this value, the lift will be marked as defective. The
non-functional status will be removed when another check or alarm call arrives in the
server from this lift. The default value of this parameter is 72 hours. The Alarm call
response specifies the type of alarm call processing:

Normal call Confirm with 1,

and

Similarly, the Check call response specifies the

CPC Antenna, CPC KONE

P100.

type of check call processing:

Reject Accept and send 5 Confirm with 1 a 5 CPC

and

Plan is the last parameter for you to choose a map of

Antenna, CPC KONE

P100.

the building. Click Save to confirm the settings