Device, Recording settings – 2N Lift8 v1.5.2 User Manual

Page 111

111

The microphone icon is dim and the name, total length and current state (active
recording, playing or recording stop) of the message to be recorded are displayed in
the player during the message recording process. Click the Stop icon to terminate
recording. Press Play to check the currently recorded or imported message. In case the
message volume is too low, adjust the output volume value. Having completed
message editing, click To device to load the message set into the

connected. Or,

click Save to directory to save the set onto your PC disk.

Recording Settings

Find the Recording settings to the left. Select one of the available input devices in
Select source: integrated or external microphone or line input. Mic level defines the
microphone input drive level. Mic gain defines the input gain. The total memory
capacity for all the messages to be saved into the

is 8 minutes. The time left for

message editing is displayed in the Time left parameter.

Device

The Device menu provides information on the

connected:

2N Lift8

Central Unit

basic parameters and text/graphic diagram of available Audio Units and splitters. In
addition, you can upgrade the

here too.

Note

The correct format for a message to be added is .WAV. No other files can
be recorded.
A message cannot be recorded until the input device is selected in the
recording settings.

Caution

The output volume value in the application does not affect the master
volume of the record to be saved into the

. Thus, if the recorded

volume is too low, record the message once again and louder.

Tip

Use high-quality microphones and properly noise-insulated rooms with
good acoustic properties for recording to avoid noise and interference in
your records.

Note

If the microphone input is overdriven during recording, turn down the mic
input gain. If the record is too silent, turn up the mic input.
In case the application gain setting is not sufficient, use the system
controllers or an external amplifier.
When the maximum message time (8 minutes) is exhausted, no more
messages can be added. Thus, optimise the message time to record all of
your messages.