2N Lift8 v1.5.2 User Manual

Page 133

133

The list in the figure above includes some information on the lift. The icon at each lift
indicates the lift cabin and can have several functions and meanings, which can be
combined (see the table below).

The red handset above the icon indicates that the lift has not made a check
call within the timeout and has been marked as non-functional. This symbol
will disappear when the lift makes a correct check call.

The yellow question mark inside the icon indicates that the lift was created by
a check call and has not been confirmed by the Administrator as a real lift.
Refer to the Lift Creation subsection below for details.

A functional lift:

or Unknown, probably

SingleTalk 2N

LiftNet

supplied by another manufacturer and able to communicate with the 2N

via CPC / P100.

Lift8 Server

A functional

lift. The red chain below the icon indicates the state of

2N Lift8

the

–

tunnel connection. This function is under

Server

Central Unit

development and so the symbol is always red.

Lift Creation

Add a lift to the database as follows:

The first way is to install a

and configure it to call the number that the server uses

for check calls. When the

makes the first check call to the server, a new lift card is

created and basic information on the lift is included: the telephone number used for the
check call is filled in as the Name. The so-created lift is marked as unauthorised to
eliminate unintentional calls (telemarketing, e.g.). To authorise this lift, use the Basic
tab for this lift in the

, which informs you that a new record has

Control Panel

been created by a call from number x and asks you whether you want to keep it in the
database or delete it. Press Preserve to add the lift to the database or Remove to
delete the lift from the database if unintentional (telemarketing, error).

Figure:

Authorisation of Lift Created by Check Call

Complete more lift card parameters for authorisation. See below for details (Lifts).

Tip

The

is able to work with the third party equipment via

2N Lift8 Server

the standard communication protocols (CPC and P100) instead of
proprietary protocols. Set the type to Unknown to communicate with such
equipment.