2N Lift8 v1.5.2 - Manual (Page 25)

25
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Figure: USB Connector Reset Button and
Reset button function
– press the button quickly. Reset equipment
– press and hold the button until all the LEDs turn red. Restore factory values
Then release the button and wait until the SYSTEM LED flashes yellow. Now press
the button quickly to delete all the user settings.
– press and hold the button Zero backup rechargeable battery life counter
until all the LEDs turn red. Then release the button and wait until the
POWER/BATTERY LED flashes yellow. Now press the button quickly. Perform this
function after replacing the backup rechargeable batteries with new ones only!
– press and hold the button until all the LEDs Check system completeness
turn red. Then release the button and wait until the INTERNAL BUS LED flashes
yellow. Now press the button quickly to make the system supervise all the
installed equipment (splitters, Audio Units etc.) for proper connection and
function.
– press and hold the button until all Delete central unit software completely
the LEDs turn red. Then release the button and wait until the SYSTEM LED
flashes red. Now press the button quickly. CAUTION: after performing this
function you can only restore the normal function of the device using a PC!
USB Port Connection
Recommendation
Do not keep your PC connected for a long time unless necessary to reduce the
computer damage due voltage surge from the telephone line during storms, for
example.
Warning
during the warranty period. Do not open the CU
Open the
only to replace after the CU the rechargeable batteries
warranty period.