2N Lift8 v1.5.2 - Manual (Page 150)

150
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Click on the first table row ('Click here to add new item') to add a SIP line. The table
columns will get displayed and the row will be validated. When all the required items
have been set, the validator approves them and the row is unselected. Now the Save
button becomes active for you to confirm the settings, Non-validated parameters
cannot be saved.
Enter the SIP Proxy address into the Domain:Port parameter. The Port parameter is not
mandatory. If you enter the SIP Proxy address only, registration port 5060 will be
used. To configure a different port, enter the port number behind a colon. Enter the
username and password for authentication towards the SIP Proxy into the Username
and Password fields respectively. The Timeout – DTMF is set in seconds and its default
value is 60. If no DTMF dialling arrives within this timeout, the call will be terminated.
Active calls signals the current count of active calls via the given SIP line. The
registration result displays the result of the SIP Proxy registration. If unsuccessful, the
registration packet will be resent. This parameter is updated every 30 s. Click Enter to
confirm the settings and add the new row to the end of the table. Now click Save to
confirm the settings. A registration packet will be sent immediately to the server. If
everything is OK, the Registration result will display a message with the 'Registered,
Code: 200, OK' header. Select a row and click Delete to remove a row from the table.
The selected SIP line will be removed from the database. Click Save to confirm the
settings.
Plans
The Plans menu helps you manage plans of the buildings in which the lifts are installed.
Assign the plans to the selected lift and mark the lift position in the Lifts menu. This
information will then be displayed to the
operators. 2N Lift8 Communicator
®
Caution
If in a state other than , the Call Server rejects all calls coming Running
to it, i.e. does not receive or process any check calls.
Note
Enter the and at least to validate a SIP line. Domain Username
Tip
Contact your network administrator or VoIP provider for correct SIP line
settings.
Just click Delete to remove the currently configured line.
If registration fails, you will find the error code (SIP error message) in the
Registration result. If your registration data are correct, contact your
network administrator.