2N Lift8 v1.5.2 - Manual (Page 41)

41
2N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
3.
4.
5.
Audio Unit Location Configuration
The Audio Unit is set as a cabin Audio Unit by default and so it is not necessary to
change the configuration. To use the Audio Unit in a room other than the lift cabin,
proceed as follows.
Procedure
Reconfigure the jumper on configuration jumper 12.
If there is poor access to the pins, you can remove the elecronics cover. Slightly
loosen the four screws and shift the cover downwards. Now you can remove the
cover.
The first 4 pins serve for setting the Audio Unit location (1 – cabin ceiling, 2 –
cabin, default, 3 – under the cabin, 4 – shaft bottom).
Configure the required changes as printed on the electronics cover.
If you have removed the cover, put it back in the original position and tighten the
screw.