2N Lift8 v1.5.2 User Manual

Page 101

101

PC COM port if you use a USB cable for connection, 'Current user' displays the currently
logged in user, 'FW version' specifies the current CU FW version and 'Serial number'
gives the CU serial number.

Upon login to the

, the Current device state is presented to the right throughout the

application. Use the arrow in the left-hand upper corner to hide/show the window
anytime. Refer to the figure below for details. The data are grouped according to
meanings. The first section provides such connection parameters as Line status
(relax/active call), GSM network with information on the currently used GSM / UMTS
network, a clearly arranged Signal intensity scale including a value in dBm, SIM
provider's name and Network type (UMTS / GSM). Roaming specifies whether the SIM
is in its home network or in the roaming mode.

Figure:

Maximum Application Display with Current Device State

The SIM card section specifies the SIM card state and IMSI and ICCID identifiers. The
GSM module section displays the GSM/UMTS module information: module
manufacturer, module type, current module FW version and module IMEI. The
Accumulator section provides details on the rechargeable batteries connected. The first
parameter of the State section describes the current device state: 'Mains supply, no
batteries' means that the

is powered from the mains and contains no batteries, for

example. The Voltage parameter measures and displays the current battery pack
voltage in mV. A very low voltage value (hundreds of mV) signals that the battery pack
is not connected. The Capacity parameter specifies the accumulator charging rate in %.
The Current parameter measures the current flowing through the accumulators: the
current is charging when the accumulators are being charged and discharging when the

has been disconnected from the power supply and fed from batteries. Remaining

CU
time defines the time in which the accumulators shall be fully charged (100%).

If your

is equipped with a VoIP module, the Real-time device state section displays

the relevant parameters; see the figure below. The section informs you of the line state
and type, IP module parameters, IP address or address obtained from the DHC server,

network mask, default gateway and DNS server. Finally, like with the GSM / UMTS