JLG 450A_AJ Series II Service Manual - Manual (Page 410)

SECTION 6 - JLG CONTROL SYSTEM
6-74 – JLG Lift – 3121180
TWR LENGTH SENSOR ONE VALUE
OUT OF RANGE LOW This fault is reported by the Ground module when the length sensor value is
outside the constant data limit
TWR LENGTH SENSOR TWO VALUE
OUT OF RANGE HIGH This fault is reported by the Ground module when the length sensor value is
outside the constant data limit
TWR LENGTH SENSOR TWO VALUE
OUT OF RANGE LOW This fault is reported by the Ground module when the length sensor value is
outside the constant data limit
TWR ANGL1 INVALID ANGLE Tower boom angle sensor #1 out of range
TWR ANGL2 INVALID ANGLE Tower boom angle sensor #2 out of range
INVALID ANGLE SENSOR #1 MODEL Wrong tower angle sensor Mfgr. Installed on a 1250AJP (Must be a Rieker, not
Spectron)
INVALID ANGLE SENSOR #2 MODEL Wrong tower angle sensor Mfgr. Installed on a 1250AJP (Must be a Rieker, not
Spectron)
MAIN ANGL1 INVALID ANGLE Main boom angle sensor #1 out of range
MAIN ANGL2 INVALID ANGLE Main boom angle sensor #2 out of range
MAIN ANGLE SENSOR NOT DETECT-
ING ANGLE CHANGE The main boom is being commanded to move and the main angle sensors are
not detecting any movement
MAIN ANGLE MOVEMENT WITHOUT
CMD The main boom angle is changing without a main lift command
WRONG TWR TELE RESPONSE The tower telescope is moving in the opposite direction the user is command-
ing.
WRONG TWR LIFT RESPONSE The tower lift is moving in the opposite direction the user is commanding
TWR CYL ANGLE SENSOR OUT OF
RANGE LOW The tower cylinder angle sensor is below 4721 A/D counts
TWR CYL ANGLE SENSOR OUT OF
RANGE HIGH The tower cylinder angle sensor is above 29535 A/D counts.
TWR CYL ANGLE NOT DETECTING
ANGLE CHANGE The cylinder angle is not changing during a tower lift up/down user command.
TWR CYL ANGLE MOVEMENT WITH-
OUT CMD The cylinder angle is changing without a tower lift command
MAIN TRN ANGLE SW FAILED The system detected a disagreement of the N.O. vs N.C. contacts on the main
boom angle switch.
TWR TRN SW DISAGREEMENT The system detected a disagreement between the tower boom length switch
and the tower length sensors.
TRN DUAL CAP SWITCHES BAD The system detected both the Dual capacity and the transport switches are
bad.
TRN DUAL CAP BAD TRANSITION The system detected that the Dual capacity or the transport switches changed
state out of order.
MAIN TRN LEN SW DISAGREEMENT The system detected a disagreement between the main boom transport length
switches.
DCAP LEN SW DISAGREEMENT The system detected a disagreement between the main boom dual capacity
length switches.
MAIN BOOM TRN ANGLE SW/SEN-
SOR DISAGREEMENT The system detected a disagreement between the main boom transport angle
switch and the main boom angle sensors.
CYL ANGLE SENSOR/SW DISAGREE-
MENT The system detected a disagreement of the tower angle input from the BLAM
and the tower cylinder angle sensor.
Table 6-8. Help Fault Codes, Displayed Faults, and Descriptions - S/N 0300066949 & S/N 1300000001 to Present
Fault Flash
Code
Communicated (Displayed on
Analyzer) Fault
Description Priority