JLG 450A_AJ Series II Service Manual - Manual (Page 388)

SECTION 6 - JLG CONTROL SYSTEM
6-52 – JLG Lift – 3121180
MOMENT: Displayed if MODEL NUMBER = 7 or 8
(LB-IN) ACTUAL XXXXXXXX Current moment value
(LB-IN)
OVER XXXXXXXX Current over moment setpoint.
(LB-IN)
UNDER XXXXXXXX Current under moment setpoint.
CAL PT
UNDER XXXXXXXX Under moment value recorded during boom sensor calibration.
CAL PT
WIT YEL XXXXXXXX Yellow witness mark moment value recorded during boom sensor
calibration.
CAL PT
WIT GRN XXXXXXXX Green witness mark moment value recorded during boom sensor
calibration.
CYL PIN
RATIO X.XXX Current cylinder moment pin ratio of X and Y forces.
PIN
E FLAGS 0xXXXX Current error flag status of cylinder moment pin.
sky welder YES/NO Status of Sky Welder selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
sky cutter YES/NO Status of Sky Cutter selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
sky glazier YES/NO Status of Sky Glazier selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
sky Bright YES/NO Status of Sky Bright selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Pipe Racks YES/NO Status of Pipe Racks selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Camera mount YES/NO Status of Camera Mount selected during boom sensor calibra-
tion. (Displayed if MODEL NUMBER = 7 or 8)
Table 6-6. Machine Diagnostics Parameters
Diagnostics
Submenu
(Displayed on
Analyzer 1
st
Line)
Parameter (Displayed
on Analyzer 2
nd
Line)
Parameter Value
(Displayed on Analyzer 2 nd
Line)
Description