JLG 450A_AJ Series II Service Manual - Manual (Page 391)

SECTION 6 - JLG CONTROL SYSTEM
3121180 – JLG Lift – 6-55
DATALOG:
ON XXXXhXXm Total controller on (EMS) time
ENGINE XXXXhXXm Engine run time
DRIVE XXXXhXXm Total controller drive operation time
LIFT XXXXhXXm Total controller lift operation time
SWING XXXXhXXm Total controller swing operation time
TELE XXXXhXXm Total controller telescope operation time
MAX TEMP XXC Maximum measured ambient temp.
MIN TEMP XXC Minimum measured ambient temp.
MAX volts XX.XV Maximum measured battery voltage
RENTAL XXXXhXXm Total controller operation time. NOTE: can be reset
ERASE RENTAL? Not available at Access Level 2.
ENTER resets rental data log time to zero.
VERSIONS:
GM SW PX.X Ground module software version
GM HW REV XXXX Ground module hardware revision
GM SN XXXXXX Ground module serial number
PM SW PX.X Platform module software version
PM HW REV XXXX Platform module hardware revision
PM SN XXXXXX Platform module serial number
cm sw PX.X Chassis module software version
bm sw PX.X BLAM module software version
c pin SW Cylinder moment load pin transmits software version.
C PIN SN Cylinder moment load pin transmits serial number.
ANALYZER VX.XXXX Analyzer software version
Table 6-6. Machine Diagnostics Parameters
Diagnostics
Submenu
(Displayed on
Analyzer 1
st
Line)
Parameter (Displayed
on Analyzer 2
nd
Line)
Parameter Value
(Displayed on Analyzer 2 nd
Line)
Description