Motor removal, Motor removal -10 – JLG 3246ES Service Manual User Manual
Page 112
SECTION 4 - HYDRAULICS
4-10
– JLG Lift –
3121166
NOTE: Be sure to remove and discard the plastic plug at the
oil inlet on the new pump before installing.
15.
Check oring on valve body and replace if neces-
sary before installing the new pump. Lubricate
orings before assembling.
NOTE: There are two orings used to seal the pump to the
valve body, one for the pump inlet (shown above)
and one on the pump boss around the drive coupler.
Motor Removal
1.
Remove the four bolts attaching the motor to the
valve body.
2.
Pull motor from valve body.
3.
Once all maintenance is performed and lift cylin-
der assembly is reinstalled on the machine,
remove fill plug and refill tank with proper grade
of oil by using a funnel. Fill until oil weeps out of
opening.
4.
Replace plug and torque to 40 ft. lbs.