Eppendorf InjectMan NI 2 - Manual (Page 8)

61
Before checking that the device has been delivered complete and installing it, please read the
following section thoroughly.
• The control board must not be carried or dragged by the joystick!
The joystick is a highly sensitive control element which transmits movement commands in
the 0.1 µm range! Always carry the unit by the housing only!
• Never place the control board upside down on the joystick
• Treat the motor modules with care!
• Never transport the motor modules while they are still assembled!
• Whenever possible, transport the motor modules in their original packaging!
• Do not tilt the assembled motor modules!
• After the warm-up phase (at least half an hour) the device is virtually drift-free.
• After switching on, wait for the initialisation process to complete before operating the joy-
stick. Completion of initialisation is indicated by an acoustic signal or by the LED returning
to its standby condition.
• Enter an injection time >0.0 for the Eppendorf injection system being used, otherwise an
error message will be delivered
2.1 Hazards when unpacking and other information and instructions
Intended use and safety precautions
2 Intended use and safety precautions
2
02_Sicher_en.fm Seite 61 Donnerstag, 6. Dezember 2012 1:27 13