Eppendorf InjectMan NI 2 - Manual (Page 10)

63
On the A module is the tool mount for the probe holders. Tools with a diameter, or width, of
4 mm and weighing max. 100 g can be inserted, e.g. capillary holders for microinjection.
Fig. 2: Module unit (here right side mounted)
1 Motor unit for horizontal movements (X/Y module)
2 Axial motor unit (A module, without tool mount)
3 A module arc guide
The control board accommodates the keypad, the display and the joystick with integral button,
as well as the turn wheel on the side. The movements performed on the joystick are transmitted
to the module unit. The movement modes, directions and speeds, as well as movement
sequences, are pre-set and triggered by way of the keypad, the turn wheel and the joystick.
Underside
The bay underneath the control board
accommodates the connector sockets for
the module unit and the mains power supply
as well as the serial port and the connection
for the FemtoJet
® and an optional foot
switch.
Note : Do not place the control board down
resting on the joystick! When connecting
cables (section 4.4), place the control board
on its side on an even surface and secure it
against toppling over!
10
10
5
5
1
2
3
3.3 Control board
3 Description
Description
3
03_Gerät_en.fm Seite 63 Donnerstag, 6. Dezember 2012 1:29 13