Eppendorf InjectMan NI 2 - Manual (Page 33)

86
5.3.2 Setting the speed
The speed can be set in three ways:
Directly using the turn wheel, by pressing and holding
down the key, or by way of the menu.
Turn wheel
The turn wheel can be used to make speed settings directly.
Turn wheel backwards: increase speed to maximum possible
Turn wheel forwards:
reduce speed to minimum possible
The setting is made in stages. Finer settings can be made by
way of the menu.
The turn wheel can also be used to navigate round the menu.
Press and hold down the Speed key
Pressing and holding down the "Speed" key in the
selected speed mode (Coarse/Fine) activates the setting,
which is then also indicated on the display. The speed is
reduced in stages.
Each stage is also indicated acoustically. If you switch
directly from the minimum to the maximum radius a long
acoustic signal sounds. There are five different levels,
each roughly halving the speed.
FINE
1000
µm/s
FINE
250
µm/s
5 User control and mode of operation
User control and mode of operation
5
05_Bedien_en.fm Seite 86 Donnerstag, 6. Dezember 2012 1:34 13