Eppendorf InjectMan NI 2 - Manual (Page 26)

79
Changing the limit
As a result of moving the petri dish, the limit may need to be adjusted. This is done using the
arrow keys to the left and right of the "Limit" key.
Each key press changes the value of the limit upwards or downwards. The new value of the limit
is checked by a test injection. Alternatively, the stored limit can be cleared by pressing the
"Limit" key again and then be redefined.
Home
To change capillaries, the Home function
can be used. Move the capillary up slightly
by rotating the joystick to the left. Press
and hold down the "Home" key. Swivel out
the motor module and change the capillary. Swivel the
motor module back into place and press the "Home"
key. The capillary is returned to its home position.
If necessary, the capillary can also be moved manually to
the sample by moving the joystick in the desired direction.
Standby
When the operation is complete, the InjectMan ® NI 2
micromanipulator can be switched off by the “Standby“
key. The display illumination is switched off and Standby
is displayed.
5.2.1 Setting up the capillary
– Mount the capillary holder (without capillary) at as high a position as possible on the
A module. Use the positioning aid if necessary.
– From the menu select the CentrMot function (see sections 5.4 and 5.4.7). Make sure there
are no obstacles blocking the field of movement!
– Run the CentrMot function. The motor unit moves towards the microscope lens.
– Swivel out module (see section 5.2.4)
– Attach the capillary to the universal capillary holder without dismantling the holder.
– Swivel motor back into place.
–3200
300
–21455
To move back use HOME
or joystick
HOME
STANDBY
5.2 More information on the mode of operation
User control and mode of operation
5 User control and mode of operation
5
05_Bedien_en.fm Seite 79 Donnerstag, 6. Dezember 2012 1:34 13