Eppendorf InjectMan NI 2 - Manual (Page 14)

67
– The packaging and the transport guards should be kept for use if the device is transported
again later!
– The control board must not be carried or dragged by the joystick!
– The joystick is a highly sensitive control element which transmits movement commands in
the 0.1 µm range. Always carry the unit by the housing only!
– Never place the control board upside down on the joystick!
– Treat the motor modules with care!
– Only remove the motor modules from their packaging together! Never tug on the module
connecting cable!
– Never transport the motor modules while they are still assembled!
– Whenever possible, transport the motor modules with the transport guards in their original
packaging!
– Do not tilt the assembled motor modules!
The packaging comprises two levels. The first level contains the accessories. The bottom level
contains the module unit and the control board.
Check that the standard accessories are present and complete.
The standard accessories are:
1 Control board
1 Motor module
1 Mains power supply unit
1 Mains power cable
1 Hinged bracket
1 Set of Allen keys (metric)
2 Screws M5x16
1 FemtoJet
® interface cable (5247)
2 Positioning aids for universal capillary holders
1 Operating manual
1 Set of spare screws
(2 x M5x16, 2 x M4x10, 2 x M3x16, 2 x M3x12)
Carefully lift the control board and the motor modules out of the packaging using both hands.
4.1 Unpacking
1. Loosen the
screws and
remove the
transport guard
(yellow).
2. Remove the colored
transport guard
only after comple-
tely mounting the
device on the
microscope!
Installation
4 Installation
4
04_Install_en.fm Seite 67 Donnerstag, 6. Dezember 2012 1:32 13