Eppendorf InjectMan NI 2 - Manual (Page 17)

70
4.2.4 Angle adjuster
Set the desired angle.
Mounting the angle guide at the centre hole and
adjusting the A module to 0° corresponds to an angle
of 45°.
To perform the adjustment, the lines on the angle
guide are moved to match the outer edge of the A
module.
Example – 35°: The angle guide is attached by the
centre hole, the bottom edge of the A module is set to
the lower 10° marking.
Note : The mechanically set angle must be entered
subsequently in the Install menu! Otherwise Z axis
movements cannot be executed correctly! See
section 5.4.2.6.
Note : The orange fixing screw on the narrow face of
the A module must be slackened prior to adjusting the
angle and must then be re-tightened in order to
ensure reliable operation.
4.2.5 Assembling the hinged bracket
Set up the hinged bracket according to the side on
which the module unit is to be mounted.
Example of left side mounting:
The hinge (2) is positioned at the left outer, aligned
upwards and to the rear.
45°
40°
35°
10
10
5
5
2
1
4 Installation
Installation
4
04_Install_en.fm Seite 70 Donnerstag, 6. Dezember 2012 1:32 13