Eppendorf InjectMan NI 2 - Manual (Page 45)

98
5.5.2 Software version polling
As an additional software version polling facility (also visible during the power-up routine on the
display) the version number can be indicated acoustically.
The version number is given in three signal sequences, with the digit 0 represented as 10.
Execution:
–
Switch device to Standby
– Press "Standby" to switch device on again and then immediately press and release "Axial"
key.
The device runs through the initialisation phase and the acoustic output begins.
5.5.3 Installation
As an alternative to the Install menu option, the installation can also be performed by way of the
keypad.
Execution:
–
device is on.
– Press "Speed" (Coarse/Fine) and "Axial" keys simultaneously.
– The Installation subfunction is activated and is indicated on the display and by the two
LEDs on the "Speed" key being lit.
– The "Home" key is used to enter right or left side
mounting. In addition, a RIGHT setting is indicated
by a short acoustic signal and a LEFT setting by a
long one.
As shown on the display, pressing
the Home key would activate left side mounting.
(Home =>LEFT)
– The "Pos 1" key is used to enter horizontal or upright
mounting of the X/Y module. In addition, an UP (upright) setting is indicated by a short
acoustic signal and a FLAT (horizontal) setting by a long one.
– Pressing and holding down the "Axial" key enters the mounting angle. In addition to the
display readout, the change of angle per 5° increment is indicated by a short acoustic
signal, a 90° setting by a long acoustic signal and a 45° setting by a double one.
– Pressing and holding down the "Menu" key initiates loading of a software update. To be
undertaken only by Service!
– Press the "Coarse/Fine" key to terminate installation and save the parameters directly.
The display switches to the routine display and only the LED of the selected speed range is
lit.
The device runs through a lengthy initialisation phase.
Coarse
Fine
Axial
Coarse
Fine
Installation
Home => LEFT
POS1 => UP
AXIAL(long) => 40°
Menu(long) => LOAD
Press COARSE to quit
5 User control and mode of operation
User control and mode of operation
5
05_Bedien_en.fm Seite 98 Donnerstag, 6. Dezember 2012 1:34 13