Apple Power Macintosh 7300 series - PC Compatibility Card - Manual (Page 4)

Connecting a monitor to your Power Macintosh 7300
Before you begin, make sure your computer and monitor are unplugged. Then
follow these steps using the loopback cable:
Plug the middle connector on the
loopback cable into the bottom port
on your PC Compatibility Card. This
connector has a triple row of pins and
an Apple (
K ) icon on either side.
Plug the long connector on the loopback
cable into the built-in monitor port
(or video card if one is installed).
Plug the short connector on the loopback
cable into your monitor’s cable. This connector
has an Apple (
K
) icon on one side and a
monitor (
™
) icon on the other.
1
2
3
4 Chapter 1
WARNING Do not plug a monitor into the joystick port (marked with the
icon ), and do not plug a joystick into a monitor port (marked with the
icon
™). Serious damage can result to your equipment.