Apple Power Macintosh 7300 series - PC Compatibility Card - Manual (Page 134)

This appendix contains instructions for installing and setting up the
following network software combinations:
ODI driver with the following protocols
m NetBEUI and IPX/SPX in Windows 95
m TCP/IP in Windows 95
NDIS 2.0 driver with the following protocols
m NetBEUI and IPX/SPX in Windows 95
m Microsoft’s TCP/IP and IPX/SPX in Windows 95
Configuring the built-in TCP/IP Stack for PPP (modem) in Windows 95
If you are installing a protocol for use with an ODI driver, see “Installing
Protocols for Use With Open Data-Link Interface (ODI),” next. If you are
installing a protocol for use with an NDIS 2.0 driver, see “Installing
Protocols for Use With Network Driver Interface Specification (NDIS) 2.0,”
later in this appendix.
Installing protocols for use with Open Data-Link Interface (ODI)
Before you install a protocol for use with ODI, follow the instructions in this
section to install the appropriate NetWare client software. Then refer to the
instructions later in this section that describe installing and setting up the
network protocol you want to use.
You need to know the Ethernet frame type in use on your network segment.
Your network administrator can give you this information.
Installing NetWare client software version 1.02 for Windows 95
The NetWare client software that’s installed under Windows 95 can use either
the NDIS or ODI driver (unlike Windows for Workgroups and DOS, where
only the ODI driver can be used). The following steps describe how to install a
NetWare client under Windows 95 using the ODI driver.
1 Switch to the PC environment and start Windows 95.
2 In Windows 95, click Start and then select Shutdown from the menu that appears.
134 Appendix D